The battery steel strapping tensioner ELECTRA M Series is a battery-operated tensioner paired with a separate double-notch sealer for steel strapping. If you secure heavy or irregularly shaped loads with steel band, you know that manual tensioning is slow, inconsistent and physically demanding. This two-piece set eliminates air hoses and power cables whilst delivering up to 7,500 N of tension force.
Why a battery steel strapping tensioner replaces manual steel strapping
Pulling steel strap tight by hand takes time, and the result varies from one operator to the next. Uneven or insufficient tension puts goods at risk during transport. Using separate hand tools for tensioning and sealing adds handling steps and cuts into your throughput. Air-powered alternatives tie you to a compressor and hose, limiting where on the floor you can work. A battery steel strapping tensioner removes those constraints.

How this battery steel strapping tensioner tensions and seals steel strap
The ELECTRA M Series consists of a tensioner and a width-specific double-notch sealer. The tensioner runs on a Makita 18 V, 3 Ah lithium-ion battery that charges fully in 20 minutes. The tensioner pulls steel strap at 3 metres per minute and applies up to 7,500 N of tension force. The sealer crimps a double-notch joint on the overlapping strap ends.
Key specifications:
- Tension force: up to 7,500 N
- Tension speed: 3 m/min
- Strap widths: 19, 25 or 32 mm (sealer is width-specific)
- Strap thickness: 0.60–1 mm
- Battery charge indicator: built in
Together, the two units form a complete set for steel strap tensioning and sealing without cables or compressed air.

Where the ELECTRA battery steel strapping tensioner fits and where it does not
This set is built for sites where you strap both regular and irregularly shaped packages with steel band. Because it runs on battery, it suits sites that need portability with no compressor and no mains connection.
Limitations to keep in mind:
- Steel strap only; not compatible with plastic or textile strapping.
- Strap widths limited to 19, 25 or 32 mm.
- Strap thickness must fall between 0.60 and 1 mm.
- If you require higher tension or a different strap material, a different tool type is needed.

What to check before you order your battery steel strapping tensioner
- Strap material: steel only.
- Strap width: select the 19, 25 or 32 mm variant. The sealer is width-specific, so it must match your strap.
- Strap thickness: 0.60–1 mm.
- Battery: Makita 18 V, 3 Ah; charges in 20 minutes.
- Set contents: tensioner and sealer sold as a pair.
Review the specification table on this page for full dimensions and ratings.






