Steel strapping seals 16-32 mm in four widths let you secure steel strap around heavy, rigid loads using a pneumatic tensioner and sealer. When your packing line handles steel coils, castings, pipes, timber bundles or bricks, the strap joint must withstand edges, vibration and rough handling. A crimped carbon-steel seal is the component that retains the tension the tool applies, long after the trigger is released.
Why steel strapping seals 16-32 mm matter for load security
A pneumatic tensioner pulls considerably harder than a hand tool. The seal receives that force and must deform without cracking when the sealer jaws notch it into both strap ends. If the seal is the wrong width, the sealer cannot close it properly: too wide and the jaws miss, too narrow and there is not enough material gripping the strap. The result in either case is a joint that opens under load.
- A slipped joint during transit can mean damaged goods, rejected deliveries and liability claims.
- Worn sealer jaws leave shallow notches, so the crimp on the first joint of every shift should be inspected.
- Corroded seals crimp poorly and can mark the goods, which is why dry indoor storage matters.

How these steel strapping seals 16-32 mm form a lasting joint
The seal slides over the two overlapping ends of the steel strap. After the pneumatic tensioner brings the strap to the required tension, the sealer is closed on the seal. Its jaws cut notches into the seal and both strap layers simultaneously, locking them together. The loose end is then cut. There is no heat, no weld and nothing in the joint that ages. One seal is used per joint, making consumable cost per pallet straightforward to calculate.
The material is high-strength carbon steel. It deforms where the sealer bites without cracking or releasing under pull. That characteristic is critical for loads exposed to vibration, handling stress and demanding transport conditions.

Where these steel strapping seals fit and where they do not
These steel strapping seals 16-32 mm are designed for pneumatic tensioners and sealers. They are not intended for manual strapping tools, which apply lower sealing forces. If your operation uses 16 mm strap with a hand tool, a different seal type is required.
- Suited for: steel sections, coils, castings, pipes, timber and bricks.
- Suited for: manufacturing plants, metal processing, timber yards, construction material distributors and export logistics.
- Not needed if you use a sealless tool that cuts the two strap ends into each other without a seal.
- If loads are not hot, sharp-edged or extremely heavy, PET strap with a battery tool may cost less per pallet.

What to check before ordering steel strapping seals 16-32 mm
Match the seal width to your strap width. A 19 mm seal goes on 19 mm strap, not 16 or 25 mm. The four available sizes are:
- 16 × 40 mm, packed in boxes of 1 000 units
- 19 × 57 mm, packed in boxes of 1 000 units
- 25 × 57 mm, packed in boxes of 1 000 units
- 32 × 57 mm, packed in boxes of 800 units
Count how many joints you make per pallet, multiply by the number of pallets you strap per week and order accordingly. Confirm that your pneumatic tool is set to the correct air pressure; under-tensioned strap produces a joint that slips at the first bump. Store all seals in a dry area to prevent corrosion before use. Wear gloves and eye protection when working with tensioned steel strap, as cut ends can spring and edges are sharp.





