GT-XTREME strapping tool: closing plastic strap on heavy packages without air lines or manual tensioners
The GT-XTREME strapping tool is a battery-powered unit that tensions and friction-welds PP and PET strap in widths of 16 mm and 19 mm, with thickness from 0.7 to 1.27 mm. If you currently strap loads by hand or with a pneumatic tool tethered to a compressor line, you know the constraints: slow cycle times, limited reach across the floor and operator fatigue from pulling tensioners shift after shift. This tool removes the air hose and lets one person strap wherever the load stands.

What slows you down without a GT-XTREME strapping tool
Manual tensioners and sealers require two separate actions per strap, and the operator sets tension by feel. The result is inconsistent hold on the package and goods that shift in transit. Pneumatic tools tie you to a fixed compressor radius; moving a pallet outside that radius means dragging hose or relocating equipment.
- Two-step manual strapping is slower and less repeatable than a single-cycle tool.
- Air hoses restrict movement and create trip hazards on busy floors.
- Operator fatigue from repeated manual tensioning raises the risk of under-tensioned loads.

How the GT-XTREME strapping tool works and what the figures mean
The GT-XTREME offers four operating modes: automatic, semi-automatic, manual and soft. Soft mode gives you finer control during the tensioning phase. A digital display shows the active mode, tension force, welding time and battery charge level. The keypad can be locked to prevent unintended parameter changes.
- Up to 4 200 N tension on a single strap, up to 8 400 N on the package.
- Tensioning speed up to 9.0 m/min.
- Joint type: friction weld seal, no metal seals or buckles needed.
- Minimum flat surface 120 mm; minimum round surface diameter 700 mm.
The brushless motor drives a bevel gear transmission. Stainless steel components resist corrosion, which matters in outdoor yards or humid production halls. Adjustable front and rear guides switch between 16 mm and 19 mm strap. At 4 kg with battery, the unit is light enough for vertical and horizontal strapping without excessive arm strain.

Where the GT-XTREME fits and where it does not
This strapping tool is designed for demanding environments such as construction sites, timber yards, and metal and glass processing. It handles PP and PET strap only; it is not intended for steel strap. The minimum flat surface of 120 mm and minimum round diameter of 700 mm set the lower size limit for packages. If your packages are smaller than that or you work with steel strap, a different tool is the right choice.

What to check before you order this strapping tool
Confirm your strap material (PP or PET), width (16 mm or 19 mm) and thickness (0.7–1.27 mm). The tool ships with a Li-Ion battery (18 V, 5 Ah) and charger. The consumables you need are PP or PET strap coils in the correct width; no metal seals are required because the joint is a friction weld.
- Strap widths accepted: 16 mm and 19 mm.
- Strap thickness range: 0.7–1.27 mm.
- Battery and charger included.
- No seals or buckles needed for operation.







