The electric pallet strapper MB820 is a battery-powered hand tool that tensions, seals and cuts PET or PP strap from 16 to 19 mm wide. If you manage packing lines or warehouse dispatch, you know that inconsistent strap tension and slow manual sealing cost you time and put loads at risk during transport.
Why your operation needs an electric pallet strapper
Strapping a pallet by hand with a separate tensioner and seal crimper means two tools, two steps and a metal seal for every strap. Each cycle takes longer, and the applied tension varies from one operator to the next. Uneven tension can allow loads to shift in transit, which causes damaged goods and rejected deliveries. Operators who repeat the manual cycle hundreds of times per shift face wrist and arm fatigue. Metal seals add a recurring consumable cost on top of the strap itself.

How this electric pallet strapper works
The MB820 performs tensioning, friction-weld sealing and cutting in one automated sequence. You place the strap around the load, feed both ends into the tool and press the start button. The tool tensions the strap to your set value, creates a friction weld seal by vibration welding, and cuts the excess strap.
- Tension adjustable from 40 N up to 4000 N by turning a dial
- Strap width: 16–19 mm; thickness: 0.7–1.27 mm
- Sealing time: 0.3–2.7 s depending on strap type and settings
- Friction weld joint retains 85 ± 5 % of strap strength
- Up to 400 strapping cycles per battery charge
- Digital display for parameter readout and adjustment
The tool works in both vertical and horizontal positions, so you can strap top-loaded pallets and side-bundled packages. A rear-end roller on the base prevents scratches on the strapped goods. Three modes are available on this pallet strapper: automatic, semi-automatic and a soft mode for fragile products. In automatic mode, a single thumb press on the start button initiates the full cycle of tensioning, sealing and cutting. The brushless motor is designed for a long service life, and the battery supports up to 2000 charge cycles with proper maintenance.

Where the MB820 pallet strapper fits and where it does not
This tool is built for PP and PET plastic strap between 16 and 19 mm wide and 0.7 to 1.27 mm thick. It suits packing lines, warehouses and production floors where pallets or bundles need consistent plastic strapping. Single-hand operation and the ability to work in vertical and horizontal positions make it practical for both top and side strapping.
The MB820 is not suitable for steel strap or for plastic strap outside the 16–19 mm width range. If your application calls for narrower or wider strap, you need a different model. For very low-volume strapping, a manual tensioner and sealer may be sufficient.

What to check before you order your electric pallet strapper
- Strap material: PET or PP only
- Strap width: 16–19 mm
- Strap thickness: 0.7–1.27 mm
- Charger input: 220 V
- Included: MB820 tool, battery and charger
- Tool dimensions: 330 × 150 × 130 mm (L × W × H)
No metal seals are required. The friction weld joint replaces them entirely, removing a consumable from your process. Confirm your strap dimensions before ordering to make sure they fall within the accepted range.





