The GT SMART Plus strapping tool is a battery-operated device that tensions and friction-welds PET or PP strap from 9 to 16 mm wide and 0.4 to 0.85 mm thick. If you strap pallets or packages by hand, you know the result: uneven tension, weak seals and tired operators by the end of a shift.
What the GT SMART Plus strapping tool replaces in your process
Hand tensioning gives a different pull on every strap. Seals applied with manual buckles or clips vary in strength, and loads can shift in transit. Each strap takes longer than it should, and the physical effort builds up over a full day. Without consistent tension, you risk damaged goods, rejected shipments and rework.

How the GT SMART Plus strapping tool tensions and seals
The tool uses a brushless motor to pull the strap at up to 14 m/min and apply up to 1800 N. You begin tensioning by pressing a dedicated button. Once the strap is tight, pressing a second button activates the friction weld, producing a seal with 75–85 % efficiency. No buckles, clips or metal seals are required.
Two functioning modes are available: manual and soft. You can use this strapping tool for horizontal and vertical applications. Both front and rear guides adjust to cover all widths in the 9–16 mm range. Switching from one strap size to another takes roughly 30 seconds, with no guide change required.

Where this strapping tool fits and where it does not
The tool is designed for PET and PP strap in warehouse and production environments. It runs on a 14.4 V Li-Ion battery, so there is no air hose or mains cable to manage. It suits pallet and package strapping where freedom from cables and hoses matters.
- Strap material: PET or PP only. Not for steel strap.
- Strap width: 9–16 mm. Outside this range, choose another tool.
- Strap thickness: 0.4–0.85 mm.
- Maximum tension: 1800 N. For loads requiring higher tension, you need a heavier tool.
What to check before you order this GT SMART Plus strapping tool
- Strap: PET or PP, 9–16 mm wide, 0.4–0.85 mm thick.
- Seal type: friction weld. No separate seals or buckles needed as consumables.
- Included: one SP3 14.4 V Li-Ion battery and one AP I 2830 MV charger. Charging time is 20 minutes.
- Functioning modes: manual and soft, selectable via a touch panel with key lock function.
- Frame: aluminium, with a natural rubber handle.







