The MB620 PP strapping kit provides you with a fully automatic battery strapping tool, a Li-Po battery, a 220 V charger, one roll of PP strap and a dispenser cart with wheels in a single order. If you run a packing line and need to start banding pallets without trawling through separate catalogues for each component, this kit takes that step away.
Loose loads and wasted time: what the MB620 PP strapping kit addresses
Purchasing a strapping tool, strap coil and cart from different suppliers creates compatibility risks. You may end up with strap that is too wide for the tool, or a cart whose core diameter does not match the coil. Each mismatch holds up the packing line.
If you currently close straps with buckles and metal seals, every joint depends on a separate consumable. Stocking seals adds cost, and an operator who runs out mid-shift stops work until more arrive.

How the MB620 tool tensions, welds and cuts each strap
The tool accepts PP and PET strap from 12 to 16 mm wide and 0.65 to 1.0 mm thick. After you loop the strap around the load, it tensions with a force adjustable from 10 N up to 2500 N. The overlapping strap ends are then welded by friction (vibration welding) and the strap is cut automatically. With this MB620 PP strapping kit, you do not need metal or plastic seals at all.
A full touch display shows the tension force in real time, alongside a three-colour status indicator and an acoustic signal. You can adjust the tension speed and select pre-programmed profiles on the touch board to suit different load types. The tool operates in both vertical and horizontal positions and allows one-hand use.
Where the MB620 PP strapping kit fits and where it does not
This kit suits warehouse and factory settings where you band pallets with PP strap in the 12–16 mm width range. The battery delivers up to 400 strappings per charge, and charging takes 15 to 30 minutes on the supplied 220 V charger.
Limitations to bear in mind:
- Strap narrower than 12 mm or wider than 16 mm falls outside the tool’s range.
- Strap thickness must sit between 0.65 and 1.0 mm.
- The kit includes PP strap only. The tool also accepts PET strap, but you would need to order PET coils separately.
What to verify before ordering your MB620 kit
When you place the order, you choose the PP strap variant you need. Each MB620 PP strapping kit variant ships with 2000 m of PP strap on a coil, together with:
- MB620 fully automatic battery strapping tool (12–16 mm)
- 14.8 V Li-Po battery and 220 V charger
- Dispenser cart with wheels (65 × 48 × 110 cm, 400 mm inner diameter for strap coils)
Tool dimensions are 330 × 150 × 130 mm. Because every seal is created by friction welding, you do not need to stock separate seals or buckles.




