The MB620 PET strapping kit gives you a fully automatic battery strapping tool, a 14.8 V Li-Po battery, a 220 V charger, one coil of PET strap and a dispenser cart with wheels in a single order. If you band heavy pallets and need PET strap for its higher tensile strength, this kit removes the step of matching separate components.
Heavy loads and seal waste: what the MB620 PET strapping kit addresses
PET strap holds tighter than PP on heavy or rigid loads, but the tool must match the strap’s width and thickness. Buying components from different suppliers risks a coil that does not seat in the cart or a strap gauge the tool cannot weld. Each mismatch delays the packing line.
If you currently close PET straps with metal seals, every joint depends on a separate consumable. Running out of seals mid-shift stops work until more arrive, and each seal adds cost per pallet.

How the MB620 tensions, welds and cuts PET strap
The tool accepts strap from 12 to 16 mm wide and 0.65 to 1.0 mm thick, covering both PP and PET. After you loop the strap around the load, it tensions with a force adjustable from 10 N up to 2500 N. The overlapping ends are then joined by friction welding (vibration welding) and the strap is cut automatically. With this MB620 PET strapping kit, you do not need metal or plastic seals at all.
A full touch display shows the tension force in real time, with a three-colour status indicator and an acoustic signal. You can adjust tension speed and select pre-programmed profiles on the touch board for different load types. The tool works in both vertical and horizontal positions and allows one-hand use.
Where the MB620 PET strapping kit fits and where it does not
This kit suits warehouses and factories that band pallets with PET strap in the 12–16 mm width range. The battery delivers up to 400 strappings per charge, and charging takes 15 to 30 minutes on the supplied 220 V charger.
Limitations to consider:
- Strap narrower than 12 mm or wider than 16 mm falls outside the tool’s range.
- Strap thickness must sit between 0.65 and 1.0 mm.
- The tool also accepts PP strap, but this kit ships with PET strap only.
- PET strap is stiffer than PP, so lighter loads that do not need high tension may be easier to band with a PP kit.
What to verify before ordering your MB620 PET kit
When you place the order, you choose the PET strap variant you need. Each MB620 PET strapping kit variant ships with one coil of PET strap, together with:
- MB620 fully automatic battery strapping tool (12–16 mm)
- 14.8 V Li-Po battery and 220 V charger
- Dispenser cart with wheels (65 × 48 × 110 cm, 400 mm inner diameter for strap coils)
Tool dimensions are 330 × 150 × 130 mm. Every seal is created by friction welding, so you do not need to stock separate seals or buckles.




