AIR DUO32 strapping tool is a pneumatic combination device that tensions and seals 32 mm steel strapping in a single operation. Operators who strap heavy industrial loads by hand know that separate tensioning and sealing steps slow the process and introduce inconsistency. This tool removes that second step: it pulls the strap tight and forms a push-type seal in one trigger cycle.
What the AIR DUO32 strapping tool replaces in your workflow
Manual strapping with separate hand tools means the operator tensions the strap, sets the tool down, picks up the sealer, crimps the seal and then starts the next joint. Each changeover costs time and introduces variation in seal quality. With the AIR DUO32 strapping tool, the operator positions the strap, triggers the tool once and moves on. Tension and seal happen in one cycle, so joint quality stays consistent across an entire shift.
For lines where throughput matters, that time saving compounds. If you strap 50 pallets per shift with four joints each, removing one tool change per joint frees measurable capacity.

How the AIR DUO32 strapping tool tensions and seals 32 mm steel strap
The tool connects to a standard compressed air supply. You wrap the 32 mm steel strap around the load, overlap the ends and place the tool over the overlap. One trigger pull does the following:
- Pneumatic gripper clamps the strap
- Tensioning cylinder pulls the free end to the set tension
- Push-type sealer forms a mechanical joint without a separate seal clip
- Tool releases the finished joint
Tension is adjustable to match the load. The push-type seal deforms the overlapping strap layers into each other, creating a joint that holds under vibration and handling shock. No separate metal seals are consumed; the strap itself forms the lock.

Where the AIR DUO32 strapping tool fits and where it does not
This tool is built for 32 mm steel strapping on heavy loads. Typical uses:
- Palletised steel coils, profiles and plate in metals processing
- Bundled timber, pipes and structural sections
- Heavy machinery parts and equipment for export
It requires a compressed air supply at the point of use. It does not work with polyester or polypropylene strapping, and it is not designed for strap widths other than 32 mm. If your operation does not have compressed air at the strapping station, consider a battery-powered alternative instead.

What to confirm before ordering the AIR DUO32 strapping tool
Before you order, check the following:
- Your strap is 32 mm steel
- You have compressed air available at the strapping station
- Your load weights and handling conditions suit steel strapping
- You do not need to strap with polyester or polypropylene
The tool is delivered without strap. You need a supply of 32 mm steel strapping and access to compressed air. No separate seal clips are required for the push-type joint.






