The BXT3 strapping tool is a battery-driven combination device that tensions, friction-welds and cuts PP or PET strap in one unit. If you strap pallets, bundles or heavy goods with plastic strap and want to move freely around the load without trailing air hoses or cables, this tool replaces both a separate tensioner and a sealer.
What goes wrong without a BXT3 strapping tool on your packing line
Hand tensioners and buckle sealers slow operators down. Every strap cycle calls for two separate hand tools and a metal seal. That means more time per strap, higher consumable cost for seals, and inconsistent tension from one package to the next. Pneumatic tools solve the force problem but tether the operator to a compressor and hose, limiting movement and adding infrastructure cost.

How the BXT3 strapping tool addresses these issues
The tool runs on a Bosch 18 V Li-Ion battery. A rocker lever opens the tensioning device so the strap can be inserted. The tension wheel then rotates to pull the strap tight, and the built-in friction welder seals the joint. A knife then cuts the upper strap. No separate seals are needed.
Three operating modes give you flexibility:
- Semi-automatic: hold the tensioning button until the set force is reached; welding and cutting follow automatically.
- Fully automatic: tap the tensioning button once and the full cycle runs on its own, suited to large quantities.
- Manual: hold the tensioning button for as long as you choose, then press the welding button separately, useful for varying load types.
Two tension ranges are available: a standard range for PET strap and a soft range for PP strap, where the tension wheel starts slowly to limit dirt build-up inside the tool. The display shows the set tension force continuously, and you adjust it with plus and minus buttons. A real-time indication of the applied tension force appears on screen, along with colour-coded status information and a strap alignment indicator.

Which variant of this BXT3 strapping tool suits your application
The BXT3 strapping tool is available in three width variants:
- BXT3-13: 9–13 mm strap, 0.4–0.8 mm thick, tension speed 0–290 mm/s, weight 3.6 kg with battery.
- BXT3-16: 12–16 mm strap, 0.5–1 mm thick, tension speed 0–220 mm/s, weight 3.8 kg with battery.
- BXT3-19: tension speed 0–120 mm/s, weight 4.3 kg with battery.
Pick the variant that matches the strap width and thickness you already use. The tool accepts both PP and PET across all three variants. It is not designed for steel strap or textile strap. If your loads call for strap wider than 19 mm, you will need a different tool.

What to verify before ordering this BXT3 strapping tool
Confirm the strap width and thickness you run. Each variant covers a defined range, and no single unit spans the full 9–19 mm. Note the following:
- All variants use a Bosch 18 V Li-Ion battery and a Bosch charger.
- The charger is available in 100, 110 or 230 V versions.
- The tool uses friction welding to seal the joint; no metal seals or buckles are needed.
- A favourite strapping function lets you store a preferred cycle setting for repeatable results.
Check the strap material you intend to use. The tool works with PP and PET only. Verify that the strap thickness falls within the range of the variant you select.







